Weltweit haben Hersteller die Vorteile unserer revolutionären Advantra™ Hochleistungs-Schmelzklebstoffe entdeckt: ausgezeichnetes Haftvermögen bei größerer Ergiebigkeit. Nutzen Sie die unvergleichliche Vielseitigkeit unseres umfassenden Angebotes an Industrieklebstoffen und verlassen Sie sich darauf, dass Ihre Verpackungen bei einer Vielzahl an Substraten und Verklebungstemperaturen versiegelt bleiben.
| Anzeigen 1 - 10 von allen Produkten |
|Swift®therm advantage 7911||KONTAKTIEREN SIE UNS|
|Advantra® PHC 9255||KONTAKTIEREN SIE UNS|
With the H.B. Fuller flow meter, we’ll scientifically monitor and collect data to give you a comprehensive analysis of your adhesive usage rates. This data will allow you to run your lines at the lowest cost and highest efficiency.
The flow meter can help reduce adhesive spend, increase accuracy, lower waste, and improve your bottom line.
See how it helped an agricultural customer:
We brought the flow meter into an agricultural customer on the west coast to compare their current adhesive with a H.B. Fuller adhesive. The flow meter was able to give an accurate read to measure total adhesive consumption on 125 bonded trays.
The test results showed that the agriculture company was able to reduce their adhesive purchase by 23% by switching to a H.B. Fuller adhesive, which is estimated to be $39,330 per year.
Flow Meter Installation
The flow meter is installed between the hot melt tank and the hot melt applicator. The unit can be used to monitor adhesive usage per package through up to four hoses. This gives a more accurate snapshot of hot melt consumption on a specific machine.
The H.B. Fuller team began evaluations with the agricultural company’s current adhesive using the flow meter to collect real time data on the amount of adhesive being used with existing line configurations. Then the H.B. fuller team converted the line to an H.B. Fuller Clean Melt product where a similar evaluation was performed. From there, the team was able to track the amount of adhesive being applied per package. After modifying the line configurations and reducing the amount of inlet air pressure to demonstrate the aggressive hot tack and quick setting nature of the Clean Melt hot melt. The flow meter was able to demonstrate that the H.B. Fuller adhesive could be applied at a lower amount per tray without compromising tray strength and integrity, saving the customer $39,330 per year in estimated adhesive usage.
During the demonstration, it was noted that some of the tray forming machines had not yet been programmed to the stitch bead pattern from the single long bead pattern over the whole tray length. The chart below provides some insight into the cost savings realized when using the stitch pattern versus the long bead, all validated with real time data from H.B. Fuller’s flow meter.
The entire test took 3 hours from start to finish.
Flow Meter Specifications